jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
Tekstowy podgląd strony 45 (kliknij aby zobaczyć)
HOW TO INSTALL REFRIGERATOR
3. How to Control the Amount of Water Supplied to Icemaker.
3-1. Confirm the amount of water supplied to the icemaker.
1. Pull out the ice bank in the upper part of the freezer compartment. Caution : � Do not put hands or tools into the chute to confirm the operation of geared motor. it may damage refrigerator or hurt hands.) � Check the operation of motor with its operation noise.
2
1
2. Apply electricity after connecting water pipe. 1) Press test switch under the icemaker for two seconds as shown below. 2) The bell rings(ding~dong) and ice tray rotates and water comes out from the icemaker water tube. 3) The water shall be supplied two or three times into the tray. The amount of water supplied for each time is small. Put a water container under the ice tray and press test switch. 4) When ice tray rotates, the water in it will spill. Collect the spilt water and throw away into the sink. 5) When ice tray has finished rotation, water comes out from the water tube. Confirm the amounts of water in the ice tray. (refer to fig. The optimum amount of water is 110cc)
Confirm the amount of water
Ice maker
Test Switch Too much Optimum level Too little
* It is acceptable if the adjusted level of water is a bit smaller than optimum level.
